MK Diamond Products Saw 157243 User Manual download pdf (Page 6)

Consult the owner’s manual for recommended accessories. Using improper accessories

may increase the risk of personal or by-stander injury.

Serious injury could occur if a power tool is tipped, or if a cutting tool is unintentionally

contacted.

Before using a power tool, check for damaged part. A guard or any other part that is

damaged should be carefully checked to determine if would operate properly and perform

its intended function. Always check moving parts for proper alignment or binding. Check

for broken parts and mountings and all other conditions that may affect the operation of

the power tool. A guard, or any damaged part, should be properly repaired or replaced.

TURN POWER OFF - Do not leave a tool until it comes to a complete stop. Always

turn a power tool OFF when leaving the work area, or, when a cut is finished.

CALIFORNIA PROPOSITION 65 MESSAGE

USE RECOMMENDED ACCESSORIES

NEVER LEAVE A TOOL UNATTENDED

NEVER STAND ON THE TOOL

CHECK FOR DAMAGED PARTS

WARNING

Some dust created by power sanding, sawing, grinding, drilling, and other construction activities con-

tain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive

harm. Some examples of these chemicals are:

• Lead, from lead-based paints

• Crystalline silica, from bricks and cement and other masonry products

• Arsenic and chromium, from chemically treated lumber

For further information, consult the following sources:

http://www.osha.gov/SLTC/silicacrystalline/index.html

http://www.cdc.gov/niosh/consilic.html

http://oehha.ca.gov/prop65/law/P65law72003.html

http://www.dir.ca.gov/Title8/sub4.html

Your risk from these exposures varies depending on how often you do this type of work. To reduce

your exposure to these chemicals, work in a well-ventilated area, and work with approved safety

equipment, such as those dust masks that are specially designed to lter out microscopic particles.

MK-170 TILE SAW SAFETY

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

No comments

MK Diamond Products Saw 157243 User Manual Page 6